Beckman Avanti J-HC Centrifuge with JS-4.2 Rotor
SKU:
BLE1700515
$19,900.00
$19,900.00
Contact to Purchase
AVANTI ® J-HC A complete solution for batch bioprocessing
HIGH CAPACITY& HIGH g -FORCE
Excellent condition, tested and ready to ship. Includes 30 day money back guarantee!
AVANTI ® J-HC A complete solution for batch bioprocessing
HIGH CAPACITY& HIGH g -FORCE
Excellent condition, tested and ready to ship. Includes 30 day money back guarantee!
- Height:86 cm (34 in); with door open 152 cm (59.9 in)
- Width:71 cm (28 in)
- Depth:86 cm (34 in); 102 cm (40.25 in) including air diverter extending from back panel
- Weight: 300 kg (660 lb)
- Approximate Acceleration Time: Maximum or slow
- Approximate Deceleration Time:Maximum, slow, timed (1 to 10 min from 500 to 0 rpm), or off
- Maximum Heat Dissipation into Room under Steady-State Conditions:2.0 kW (6,900 Btu/hr)
- Noise Level 1 Meter in Front of Centrifuge:<= 60 dBA
- Set Speed:100 to 10,000 rpm (ARIES rotors: 1000 to 10,000 rpm) in 10-rpm increments; or RCF from 200 g to maximum for the installed rotor (in 10 g increments)
- Set Temperature:-10° C to +40° C in 1° C increments
- Set Time:1 min to 99 hr 59 min (timed run), total centrifugal effect (g-seconds), or continuous (hold)
- Speed Control:actual rotor speed ±25 rpm; g force control sets speed to the nearest 50 rpm
- Temperature Control:± 2° C of set temperature (from 1,000 to 10,000 RPM)
- Ambient Temperature Range:15° C to 40° C
- Clearances Required:7.6 cm (3.0 in) sides; 16.0 cm (6.25 in) rear
- Humidity Restrictions:< 95% (noncondensing)
- Pollution Degree:2
- Rotor Chamber Diameter:58.4 cm (23 in)
- Time -- Actual Display:Indicates run time remaining (timed run), g-seconds setting and time remaining to accumulate set g seconds (g-seconds run), or elapsed time (hold run)
- Finish: Polycarbonate overlay on top surface of door; urethane paint on door edges and lower surface. Control panel: polyester with polycarbonate coating overlay
- Rotor Type:High Performance - Swinging Bucket
- Maximum Speed:4,200 rpm
- Maximum RCF at r max (g):5,020 x g
- k-Factor:11,500
- Rotor Material:Anodized Aluminum
- Bucket Material:Anodized Aluminum
- Imbalance Tolerance:10 g
- r min:114.0 mm
- r av:184.0 mm
- r max:254.0 mm
- Nominal Rotor Capacity:6 L, 6 blood bags, 18 microplates, 336 RIA tubes
- Number of Rotor Cavities x Nominal Largest Load Capacity:1 L bottle, or 1 quad pack blood
1 available